K 1500 Yukon XL 4WD V8-8.1L VIN G (2001)
3. Remove the upper extension from the trim panel by lifting up and out.
INSTALLATION PROCEDURE
1. Position the lower retainer to the trim panel.
2. Align the upper retainer clip to the door frame.
3. Install the upper extension by pressing into place until fully seated.
Windshield Pillar Garnish Molding Replacement
Windshield Pillar Garnish Molding Replacement
Removal Procedure
1. Pull the molding straight out in order to release the retainers.
2. Disconnect the electrical connector.
3. Remove the windshield garnish molding.
Installation Procedure
1. Connect the electrical connector.
2. Ensure the bottom of the molding is seated in the slots on the I/P.
3. Align the molding retainers to the slots.
4. Press the moldings straight in till fully seated.
