K 1500 Yukon XL 4WD V8-8.1L VIN G (2001)
7. Install the J 38416 (2) onto the J 42846 (1) in order to remove the crankshaft balancer. Place the legs of the J 38416 into the recesses cast into the
backside of the balancer inner hub.
8. Tighten the center screw of the J 38416 until the crankshaft balancer is clear of the crankshaft nose.
9. Remove the crankshaft balancer.
10. Remove the J 42846 from the end of the crankshaft.
Installation Procedure
Important:
^
The balancer should be positioned onto the end of the crankshaft as straight as possible prior to tool installation.
^
Apply grease or clean engine oil to the inside of the crankshaft balancer or the end of the crankshaft, to prevent galling during assembly.
1. Install the balancer onto the end of the crankshaft.
2. Install J 42845 to the crankshaft balancer.
