K 1500 Yukon XL 4WD V8-8.1L VIN G (2001)
Suspension Strut / Shock Absorber: Service and Repair
Rear Shock Absorber
Shock Absorber Replacement
Shock Absorber Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the electrical connector and air line if equipped with Real Time Damping (RTD).
3. Support the rear axle.
4. Disconnect the RTD sensor (if equipped). Refer to Rear Position Sensor Replacement - Electronic Suspension in Real Time Damping (RTD).
5. Remove the upper shock absorber nut and the bolt.
6. Remove the lower shock absorber nut and the bolt.
7. Remove the shock absorber.
Installation Procedure