K 2500 Suburban 4WD V8-350 5.7L (1994)
Distributor: Service and Repair
Distributor Shaft, Pole Piece & Pickup Coil
Typical Distributor Components
REMOVAL:
-
With distributor removed, disconnect wires at module terminals
-
Remove roll pin from drive gear by driving out with 1/8 inch diameter drift punch. Mark shaft and driven gear so they can be aligned for
assembly.
-
Remove gear, shim and tanged washer from distributor shaft. Remove any burrs that may have been caused by removal of pin.
-
Remove distributor shaft from housing. Bushings in housing are not serviceable.
-
Remove retainer from inside pickup coil assembly.
-
Remove pickup coil assembly from housing.
INSTALLATION:
-
Install pickup coil.
-
Fit tab on the bottom of coil into anchor hole in housing.
-
Connect pickup coil wiring connector to module.
-
Make sure locking tab is in place.
-
Install shield onto coil.
-
Install retainer onto shield.