K 2500 Suburban 4WD V8-350 5.7L (1994)
TOOL REQUIRED:
-
J 25034-B Puller
-
J 25033-B Pulley Installer
REMOVE OR DISCONNECT
-
Place a drain pan below the pump.
1. Hoses. Cap the hoses.
2. Unload the tensioner assembly.
3. Belt.
4. Pulley (35).
-
Install J 25034-B. Be sure the pilot bolt bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
-
Hold the pilot bolt.
-
Turn the nut counterclockwise.
5. Front mounting bolts (36).
6. Pump (33).
INSTALL OR CONNECT
1. Pump (33).
2. Mounting bolts (36).
TIGHTEN
-
Bolts to 50 Nm (37 lbs. ft.).
3. Brace (38).
TIGHTEN
-
Nut (40) to 50 Nm (37 lbs. ft.).
-
Bolt to 33 Nm (24 lbs. ft.).
4. Pulley
-
Place pulley on the end of the pump shaft.
-
Install J 25033-B. Be sure the pilot bolt bottoms in the shaft by turning the nut to the top of the pilot bolt.
-
Hold the pilot bolt.
-
Turn the nut clockwise.
-
Install pulley flush ± 0.25 mm (0.010 in.) with the end of the power steering pump shaft.