K 2500 Suburban 4WD V8-350 5.7L (1994)
^
Ring (3) must be firmly seated in groove on shaft.
15. Shaft lock cover (2).
NOTICE: Gently pull lower turn signal wires to remove any wire kinks that may be inside steering column assembly. Failure to do so may cause
damage to wire harness.
16. Refer to "Steering Column Components Replacement" to complete remaining steering column assembly.
17. Negative (-) battery cable.
Ignition Lock Cylinder & Upper Column Components - Floor Shift
UPPER COLUMN
INCLUDES:
SHAFT LOCK
TURN SIGNAL CANCELLING CAM ASM
UPPER BEARING SPRING
THRUST WASHER
BUZZER SWITCH ASSEMBLY
STRG COLUMN LOCK CYLINDER SET
TOOLS REQUIRED:
^
J 23653-C Lock Plate Compressor
IMPORTANT
^
Before doing any service procedures in this section, removal of Steering Wheel is needed.
