K 2500 Suburban 4WD V8-5.7L VIN R (1999)
Parking Brake Cable: Service and Repair
Park Brake Cable Replacement - Rear
REMOVAL PROCEDURE
1. Release the parking brake.
2. Raise the vehicle and support the vehicle with safety stands.
3. Loosen the nut at the equalizer.
4. Remove the connector.
5. Disconnect the rear brake assembly.
6. Bend the retaining fingers at the backing plate.
7. Disconnect the cable.
INSTALLATION PROCEDURE
1. Install the cable.
2. Connect the cable end into the backing plate. Make sure all retaining fingers are completely through the backing plate.
3. Connect the rear brake assembly.
4. Install the connector.
5. Adjust the rear cable.
