K 2500 Suburban 4WD V8-5.7L VIN R (1999)
1. Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (4) to the power steering pump.
-
Tighten the power steering gear inlet hose (4) at the power steering pump to 27 Nm (20 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the power steering gear inlet hose (4) to the power steering gear.
-
Tighten the power steering gear inlet hose (4) at the power steering gear to 27 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.
