K 2500 Suburban 4WD V8-5.7L VIN R (1999)
1. Install the oil pressure sensor fitting, if removed.
1.1.
Tighten the engine oil pressure sensor fitting to 15 Nm (11 ft. lbs.).
IMPORTANT: Do not loosen the fitting. Do not tighten more than one turn.
1.2.
Tighten the fitting until properly align.
2. Install the oil pressure sensor.
3. Hold the oil pressure sensor fitting with a wrench to prevent from turning.
-
Using J 41712 tighten the oil pressure sensor to 30 Nm (22 ft. lbs.).
4. Install the electrical connector.
