K 2500 Suburban 4WD V8-5.7L VIN R (1999)
Vehicle Speed Sensor: Service and Repair
Automatic Transmission - 4L60-E
Removal Procedure
^
Required Tools
-
J 38417 Speed Sensor Remover
1. Remove the harness connector
2. Remove the bolt.
3. Remove the vehicle speed sensor using J38417. Have a suitable container in order to catch the fluid.
4. Remove the O-ring seal.
Installation Procedure
^
Required Tools
-
J 38417 Speed Sensor Remover
1. Install the new speed sensor and O-ring seal using J 38417.
2. Coat the seal with a thin film of transmission fluid.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the bolt.
^
Tighten the bolt to 11 Nm (97 inch lbs.).
4. Install the harness connector.
5. Refill the fluid as required.
