K 2500 Suburban 4WD V8-5.7L VIN R (1999)
5. Remove the cover from the buckle assembly which conceals the nut.
6. Remove the nut from the buckle assembly to floor weld stud.
7. Remove the seat belt warning wire from the buckle assembly on the driver's side only.
8. Remove the buckle assembly from the vehicle.
Installation Procedure
1. Install the buckle assembly to the floor panel.
2. Install the seat belt warning wire to the buckle assembly on the driver's side only.
Notice: Refer to Fastener Notice in Cautions and Notices.
