K 2500 Suburban 4WD V8-5.7L VIN R (1999)
6. Remove the Inflatable Restraint front end discriminating sensor from the vehicle.
Important: The following procedures should be utilized in the event that sensor mounting holes or fasteners are damaged to the extent that the sensor
may no longer be properly mounted.
Use the following procedure to repair fasteners:
6.1. Remove and discard the fastener.
6.2. Chisel off the damaged weld nut.
6.3. Condition the front end lower tie surface where the new weld nut is to be installed.
6.4. Install the new weld nut (part #11514034) or equivalent into position.
6.5. Migweld the new weld nut to the front end lower tie surface in the correct location.
6.6. Use the new fastener (part #11515926) or equivalent.
