K 2500 Suburban 4WD V8-5.7L VIN R (1999)
5. Position the J41364-A onto the park/neutral position switch. Ensure that the two slots on the switch where the manual shaft is inserted are lined up
with the lower two tabs on the tool.
NOTICE: Refer to Fastener Notice in Service Precautions.
6. Rotate the tool until the upper locator pin on the tool is lined up with the slot on the top of the switch.
^
Tighten the bolts securing the switch to 28 Nm (21 ft. lbs.).
7. Remove the J41364-A from the switch.
8. Install the wiring harness connectors to the switch.
9. Install the transmission control lever to the manual shaft with the nut.
^
Tighten the control lever nut to 28 Nm (21 ft. lbs.).
10. Lower the vehicle.
11. Connect the negative battery cable.
12. Inspect the switch for proper operation. The engine must start in the Park or Neutral positions only. If adjustment is required, loosen the switch
retaining bolts and rotate the switch slightly, then tighten the bolts and check the switch for proper operation or refer to Park/Neutral Position
Switch Adjustment.
