K 2500 Suburban 4WD V8-5.7L VIN R (1999)
Alternator: Service and Repair
Generator Brace Replacement - Auxiliary (CS 130D)
REMOVAL PROCEDURE
1. Remove the drive belt.
2. Remove the mounting bolts from the brace. The right-mounted version of the same generator is supported by a different brace at the rear of the
generator.
3. Remove the brace.
INSTALLATION PROCEDURE
1. Install the brace.
NOTE: Refer to Fastener Notice in Cautions and Notices.
2. Install the mounting bolts to the brace.
Tighten
-
Tighten the auxiliary generator mounting long bolts to 50 N.m (37 lb ft)
Tightening specifications include bolts for right mounted brace.
-
Tighten the auxiliary generator mounting short bolts to 25 N.m (18 lb ft)
3. Install the drive belt.
