K 2500 Suburban 4WD V8-5.7L VIN R (1999)
Fuse Block: Service and Repair
Fuse Block Replacement (Convenience Center)
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Disconnect the wiring connectors at the front of the convenience center.Label the wires for reassembly.
3. Disconnect the convenience center from the bulkhead connector.
3.1. Disengage the tabs at the upper left and lower right posts.
3.2. The tabs clip into the bulkhead connector and these tabs separate the bulkhead connector from the convenience center.
4. Disconnect the wiring connectors from the rear of the convenience center.Label the connectors for reassembly.
5. Remove the convenience center from the vehicle.
INSTALLATION PROCEDURE
1. Install the convenience center into the vehicle.
2. Connect the wiring connectors to the rear of the convenience center in the original locations.
3. Connect the convenience center to the bulkhead connector.
Engage the post tabs of the convenience center to the bulkhead connector.
4. Connect the wiring connectors to the front of the convenience center in the original locations.
5. Connect the negative battery cable.
