K 2500 Suburban 4WD V8-5.7L VIN R (1999)
Power Steering Pressure Control Valve: Service and Repair
REMOVAL PROCEDURE
1. Remove the power steering pump from the vehicle.
2. Remove the Power Steering (PS) solenoid actuator discharge fitting, and the flow control valve.
INSTALLATION PROCEDURE
1. Install the flow control valve, the discharge fitting, and the electronic variable orifice solenoid to the pump.
-
Tighten the PS solenoid actuator to 62 Nm (46 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the power steering pump to the vehicle.
