K 2500 Truck 4WD V8-305 5.0L VIN M SFI (1998)
Description
34. Place a power source, 12 V minimum 2 A minimum (i.e., a vehicle battery) near the shorted end of the harness.
35. Separate the two ends of the driver deployment harness wires.
36. Connect the driver deployment harness wires to the power source in order to deploy the inflatable restraint steering wheel module.
37. Disconnect the driver deployment harness wires from the power source.
Description
38. Separate the two ends of the passenger deployment harness wires.
39. Connect the passenger deployment harness wires to the power source in order to deploy the inflatable restraint IP module.
40. Disconnect the passenger deployment harness wires from the power source.
41. Twist together one end of each wire on the driver deployment harness in order to short the wires.
42. Twist together one end of each wire on the passenger deployment harness in order to short the wires
43. Remove the drop cloth from the vehicle.
44. Disconnect both harnesses from the vehicle.
45. Discard the harnesses.
46. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
47. If one or both of the modules did not deploy, perform the following steps:
47.1. Remove the undeployed module(s) from the vehicle. Refer to Infl Rst Steering Wheel Module Replacement and Infl Rst Instrument Panel
Module Replacement.
47.2. Temporarily store the module(s).
47.3. Call the Technical Assistance Group for further assistance.
Inflatable Restraint Steering Wheel Module
Tools Required
^
J 38826 SIR Deployment Harness
^
An appropriate pigtail adapter
CAUTION: In order to prevent accidental deployment of the air bag which could cause personal injury, do not dispose of an undeployed
inflator module as normal shop waste. The undeployed inflator module contains substances that could cause severe illness or personal injury if
the sealed container is damaged during disposal Use the following deployment procedures to safely dispose of an undeployed inflator module.
Failure to dispose of an inflator module as instructed may be a violation of federal, state, province, or local laws.
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed. Failure to follow
the procedures in the order listed may result in personal injury.
Deploy the inflatable restraint steering wheel inflator module outside of the vehicle when the vehicle will be returned to service. Situations that require
deployment outside of the vehicle include the following:
^
Using the SIR diagnostics, you determine that the inflator module does not function properly.
^
The inflator module is scratched or ripped on the cover.
^
The inflator module pigtail (it equipped) is damaged.
^
The inflator module connector is damaged.
^
An inflator module connector terminal is damaged.
Deployment and disposal of a malfunctioning inflator module is subject to any required retention period.
1. Turn the ignition switch to the OFF position.
2. Remove the ignition key.
