K 2500 Truck 4WD V8-305 5.0L VIN M SFI (1998)
2. Drive the outer bearing cup into hub using the J8608 and the J8092.
IMPORTANT: Install the J8608 upside down on the J8092 so that the chamfer does not contact the bearing cup.
3. Drive the outer bearing cup (7) beyond the retaining ring groove.
4. Install the retaining ring (11) in the groove.
5. Drive the outer bearing cup onto the retaining ring (11) using the J24426.
6. Install the inner bearing cup using the J24427 and the J8092.
7. Drive the inner bearing cup until it is seated against the hub shoulder.
8. Install the inner bearing (1).
9. Install a new oil seal (2) using the Axle Shaft Seal Installer.
10. Install the hub and drum assembly (3). Refer to Hub and Drum Assembly Replacement.
11. Install the wheel bearing adjusting nut (8).
12. Adjust the bearing preload. Refer to Wheel Bearing Adjustment (10 1/2 Inch Ring Gear).
13. Install the axle shaft (5). Refer to Axle Replacement (11 Inch Ring Gear).
