K 2500 Truck 4WD V8-305 5.0L VIN M SFI (1998)
11. Inspect the outer diameter of the transmission yoke for burrs. Burring damages the transmission seal.
12. Inspect the slip yoke splines for wear.
13. Inspect for twisted slip yoke splines or possibly the wrong universal joint.
14. Inspect the universal joint bearings for wear.
Replace as necessary.
INSTALLATION PROCEDURE
1. Install the propeller shaft into the transmission.
2. Lubricate the slip joint spline with chassis grease.
3. Align the reference marks on the pinion flange and the propeller shaft rear yoke.
4. Install the yoke and cross assembly onto the fixed yoke.
5. Install the retainers.
6. Install the bolts.
-
Tighten the bolts to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
Propeller Shaft Replacement - Two-Piece
REMOVAL PROCEDURE