K 2500 Truck 4WD V8-379 6.2L DSL (1988)
Lower Side Moulding / Trim: All Technical Service Bulletins
Exterior - Body Side Molding/Emblem Gap
GMC NUMBER:
88-T-37
GROUP:
10 - Body Section
DATE:
September, 1987
CORPORATE
NUMBER:
861505
SUBJECT:
SERIES EMBLEM TO BODY SIDE MOLDING GAP
MODELS:
1988 C/K
Some 1988 C/K models may have a gap between the series emblem and the body side molding on the front door. If this gap exists, it can be eliminated
by performing the following procedure:
^
Remove series emblem from the body side molding.
Note:
Removal is accomplished by pulling or prying.
^
Clean all dirt, oil and grease from the back of the series emblem and the body side molding.
^
Using 3M tape P/N 6379 or 6380 (or equivalent), cut two pieces three inches long.
