K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
4.
Make repair.
When using a new terminal:
a.
Slip cable seal away from terminal (if seal exist).
b.
Cut wire as close to terminal as possible.
c.
Slip a new cable seal onto wire (if necessary).
d.
Strip 3/16" (5 mm) of insulation from wire.
Figure 17
e.
Crimp a new terminal to the wire (Figure 17).
f.
Solder with rosin core solder.
g.
Slide cable seal toward terminal (if equipped with a seal).
h.
Crimp cable seal and insulation (if equipped with a seal, see Figure 17).
i.
Apply grease to connectors outside the passenger compartment where the connector originally was equipped with grease.
To re-use a terminal or lead assembly, see previous steps c through i for repairs. Be sure to keep cable seal (if equipped) on terminal side of splice.
5.
Insert lead from the back until it catches.
Figure 18
Figure 19
6.
Install TPA's, CPA's and/or secondary locks, if equipped (see Figures 18 & 19).
Repairing Connectors
The following general repair procedures can be used to repair most types of connectors. The repair procedures are divided into three general groups:
Push-to-Seat and Pull-to-Seat and Weather Pack.
^
See CONNECTOR TERMINAL I.D. to determine which type of connector is to be serviced.
