K 2500 Truck 4WD V8-379 6.2L DSL VIN C FI (1989)
Voltage Check
TESTING FOR VOLTAGE
1. Connect one lead of a test light to a known good ground. When using a voltmeter, be sure the voltmeter's negative lead is connected to ground.
2. Connect the other lead of the test light or voltmeter to a selected test point (connector or terminal).
3. If the test light illuminates, there is voltage present. When using a voltmeter, note the voltage reading.
Continuity Check through a Switch
TESTING FOR CONTINUITY
1. Remove the fuse to the circuit involved.
2. Connect one lead of a self-powered test light or ohmmeter to one end of the part of the circuit you wish to test.
3. Connect the other lead to the other end of the circuit.
4. If the self-powered test light glows, there is continuity. When using an ohmmeter, low or no resistance means good continuity.
