K 2500 Truck 4WD V8-393 6.5L DSL (1994)
1. Oil seal into the bore using J 24384.
-
Lubricate the inside diameter of the new oil seal with extreme pressure lubricant.
-
Pack the cavity between the pinion stem, pinion flange and pinion nut washer with a non-hardening sealer such as Permatex(R) Type A or
equivalent. Do not coat the bearing.
2. Flange using J 8614.
-
Use marks scribed previously for installation.
3. A new pinion nut, using J 8614-01.
-
Use marks scribed previously for installation.
-
Tighten pinion nut to 596 to 678 Nm (440 to 500 ft. lbs.).
4. Propeller shaft.
