gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

All Technical Service Bulletins for Flywheel: > < Tightening Specifications|Page 5147
Page 1
background image

Flywheel: Customer Interest
Engine - Rattle Noise/No Throttle Response on Start Up

Group Ref.: 6 - Engine

Bulletin No.: 466102

Date: June, 1994

SUBJECT:
SEVERE RATTLE NOISE AND NO THROTTLE RESPONSE ON START-UP (REPLACE FLYWHEEL)

MODELS:
1992-94 CHEVROLET AND GMC TRUCK C/K 2, 3 MODELS WITH 6.5L TURBO-DIESEL (VIN CODE F - RPO L65), AND 5-SPEED MANUAL
TRANSMISSION (RPO MT8)

CONDITION:
Some owners may experience a severe rattle noise along with reduced idle speed and no throttle response while starting their vehicle. This noise has been
described in some cases as sounding like a machine gun. These conditions are more likely to occur on a hot restart with the A/C engaged. The lack of
throttle response may last five or more seconds but ALWAYS accompanies this condition.

Important:

This condition should not be confused with the normal noise heard as the engine is started up or turned off. This noise lasts from 1 to 2 seconds, and
will not interfere with throttle response.

CAUSE:
The dual mass flywheel (DMF) goes into a resonance condition and the damper is unable to provide proper damping.

CORRECTION:

Replace the DMF with the part number listed below.

Important:

These revised parts were installed in production approximately February 1, 1994. The revised parts are identified by the letter M stamped on the
engine side of the flywheel near the outer row of rivets. This letter M is also covered with a dot of white paint.

SERVICE PROCEDURE:
Replace the DMF following procedures as outlined in the appropriate C/K Service Manual, Section 6A6 - Flywheel Replacement.

SERVICE PARTS INFORMATION:

P/N

Description

QTY

15986799

Flywheel A

1

(L65)

Parts are currently available from GMSPO.

WARRANTY INFORMATION:
For vehicles repaired under warranty, use:

Labor
Operation

Description

Labor Time

J1420

Flywheel,

Use Published

Replace

Labor Operation

Time

All Technical Service Bulletins for Flywheel: > < Tightening Specifications|Page 5147