K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
Connecting Rod Bearing: Testing and Inspection
Micrometer Method
CAUTION: Do not shim, scrape, or file bearing inserts. Do not touch the bearing surface of the insert with bare fingers. Skin oil and acids will etch the
bearing surface.
1. Measure the crankpin diameter with a micrometer in several places, approximately 90 degrees apart, and average the measurements.
2. Compute the taper and the out of round.
3. Install the connecting rod bearings into the connecting rod bearing cap and the connecting rod.
4. Install the connecting rod bearing caps and the nuts
^
Tighten the nuts to 61 Nm (45 ft. lbs.).
5. Measure the bearing inside diameter (ID) using an insides micrometer.
6. Compare the connecting rod bearing clearance specifications.
7. If the bearing clearance is within specifications, the bearing is satisfactory. If the clearance is not within specifications, replace the bearing. Always
replace both the upper and the lower bearings as a unit.
8. A standard or undersize bearing combination may result in the proper clearance. If the proper bearing clearance cannot be achieved using the
standard or the undersize bearings, it will be necessary to replace or repair the crankshaft.
