K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
2. Install the fuel rail attaching bolts and stud
^
Tighten the bolts to 10 Nm (89 inch lbs.)
^
Tighten the stud to 25 Nm (18 ft. lbs.)
3. Install the Manifold Absolute Pressure (MAP) sensor retainer and nut to the lower intake manifold.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
NOTE: Do not Install thermostat without rubber O-ring seal. Omitting rubber O-ring seal may result in poor engine warm-up and reduced
heater performance.
4. Install the thermostat, coolant housing, and bolts to the lower intake manifold.
^
Tighten the bolts to 40 Nm (30 ft. lbs.).
5. Install the coolant temperature sensor to the lower intake manifold.
^
Tighten the bolt to 20 Nm (15 ft. lbs.).