K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
NOTICE: The remaining steps are to be folio wed in the unlikely event that the inflatable restraint steering wheel module did not deploy after following
these procedures.
33. Make sure that you disconnect the SIR deployment harness from the power source. Make sure that you have shorted the two banana plugs
together.(Figure 21).
34. Disconnect the pigtail adapter from the inflatable restraint steering wheel module.
CAUTION: When you are carrying an undeployed inflator module:
^
Do not carry the inflator module by the wires or connector on the inflator module.
^
Make sure the bag opening points away from you.
When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module
rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free
space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.
35. Temporarily store the inflatable restraint steering wheel module with its vinyl trim cover facing up.
36. Call the Technical Assistance group for further assistance.
Instrument Panel (I/P) (Passenger) Module
CAUTION: In order to prevent accidental deployment of the air bag which could cause personal injury, do not dispose of an undeployed
inflator module as normal shop waste. The Undeployed inflator module contains substances that could cause severe illness or personal injury if
the sealed container is damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed inflator module.
Failure to dispose of an inflator module as instructed may be a violation of federal, state, or local laws.
General Motors dealers should refer to the latest General Motors Service Bulletins for live (undeployed) inflatable restraint 1/P module scrapping and
disposal procedures. All others should contact a local General Motors dealership for live inflatable restraint I/P module scrapping and disposal
procedures. Dispose of deployed inflatable restraint I/P modules through normal refuse channels.
