K 2500 Truck 4WD V8-454 7.4L VIN J SFI (1997)
NOTE: Remove the steering gear from vehicle.
DISASSEMBLE
NOTE: Rotate stub shaft back and forth to drain fluid.
1. Retaining ring (1) by using a punch inserted into the housing access hole to unseat it.
2. Plug (2).
3. O-ring seal (3).
ASSEMBLE
NOTE: Lubricate O-ring seal with power steering fluid.
1. O-ring seal (3) into housing (20).
2. Plug (2).
3. Retaining Ring (1). Install retaining ring (1) so that open end is approximately 25 mm (1 inch) from access hole in housing (20).
4. Install or connect the steering gear.
Adjusting Plug Assembly Replacement