K 2500 Truck 4WD V8-5.3L VIN T (1999)
7. Install the fuel and EVAP pipes into the transfer case bracket clip (4 wheel drive only).
8. Install the fuel and EVAP pipes into the transmission bracket clip.
9. Install the fuel and EVAP pipes into the bellhousing stud clip (4).
10. Lower the vehicle.
11. Remove the caps from the fuel rail pipes and the engine compartment pipe.
12. Connect the engine compartment EVAP pipe (6) to the chassis EVAP pipe (3).
13. Connect the fuel feed and return pipes (1 and 2) to the fuel rail.
14. Tighten the fuel filler cap.
15. Connect the negative battery cable.
16. Inspect for leaks.
16.1. Turn the ignition switch ON for 2 seconds.
16.2. Turn the ignition switch OFF for 10 seconds.
16.3. Turn the ignition switch ON.
16.4. Inspect for fuel leaks.
Engine Compartment
