K 2500 Truck 4WD V8-5.7L VIN R (1996)
1. Upper intake manifold gasket.
2. Upper intake manifold.
-
Use care not to pinch the injector lines between the upper and lower intake manifolds.
3. Upper intake manifold bolts. Note the marks made at disassembly for proper stud location.
Tighten
-
Bolts in two steps.
-
The first pass to 5 Nm (45 lb. in.).
-
The final pass to 10 Nm (83 lb. in.) Install the two corner studs first to help align the two halves.
4. Purge solenoid and bracket.
5. Ignition coil and bracket.
6. PCV hose at upper intake manifold.
7. Fuel lines from intake to the rear of the block.
8. Cruise control cable.
9. Throttle linkage and bracket from upper intake manifold.
10. Wiring harness connectors and brackets.
11. Air cleaner intake duct.
12. Negative battery cable.
