K 2500 Truck 4WD V8-6.0L VIN U (1999)
4. Disconnect the EVAP purge solenoid electrical connector.
5. Remove the EVAP purge solenoid mount bolt (2).
6. Remove the EVAP purge solenoid (3) and the insulator (1) from the engine.
INSTALLATION PROCEDURE
1. Install the insulator (1) on the EVAP purge solenoid (3).
2. Install the EVAP purge solenoid (3) to the engine.
NOTE: Refer to the Fastener Notice in Service Precautions.
3. Install the EVAP purge solenoid mount bolt (2).
Tighten
Tighten the EVAP purge solenoid mount bolt to 10.5 N.m (93 lb in).
