K 2500 Truck 4WD V8-6.0L VIN U (1999)
1. Install the pump.
2. Install the bolts to the front and the rear of the pump.
NOTICE: Refer to Fastener Notice in Service Precautions.
-
Tighten the bolts to 50 Nm (37 ft. lbs.).
3. Install the hoses to the pump.
-
Tighten the nut to 28 Nm (20 ft. lbs.).
4. Install the pulley.
-
Place the pulley on the end of the pump shaft.
-
Install the J 25033-B.
-
Be sure the pilot bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
-
Hold the pilot bolt.
-
Turn the nut clockwise.
-
Install the pulley with 0.5 mm (0.020 inch) play.
5. Install the drive belt.
6. Install the upper radiator shroud.
7. Fill the system.
8. Bleed the power steering system.
