K 2500 Truck 4WD V8-6.0L VIN U (1999)
-
Tighten the nut to 80 Nm (59 ft. lbs.).
6. Install the upper insulator to the shock absorber.
IMPORTANT: The upper insulators are substantially larger that the lower insulators. The upper insulator (1) must be installed above the shock
mounting bracket on the frame. The plastic pilot ring (2) will assist the alignment of the isolators.
7. Install the nut to the tennon end. Do not tighten the nut.
8. Remove the safety stands.
9. Lower the vehicle.
10. Hold the tennon end with a wrench while torquing the nut.
-
Tighten the nut to 20 Nm (15 ft. lbs.).
11. Connect the electrical connector using the following procedure if equipped with selectable ride.
11.1.
Verify that the connector is unlocked.
11.2.
Align the connector so that the tabs (1) are perpendicular to the wrench flats on the tennon end.
11.3.
Engage the connector to the tennon by firmly pushing the connector down.
11.4.
Grasp the connector lock tabs (1, 2). Rotate the connector counter clockwise.
