K 2500 Truck 4WD V8-6.0L VIN U (1999)
1. Ensure the upper half of the control valve body is installed. Refer to Valve Body.
2. Install the 3-4 accumulator piston oil ring seal (1) onto the 3-4 accumulator piston (2).
3. Install the 3-4 accumulator pin (4) into the valve body (3).
4. Install the 3-4 accumulator piston (2) onto the pin (4).
5. Install the 3-4 accumulator piston spring (1).
6. Install the checkball (1) into the valve body (2).
Use a small amount of J 36850 in order to keep the checkball in the valve body.
