K 2500 Truck 4WD V8-6.0L VIN U (1999)
Important: The shift cable is a two piece shift cable.
The front or rear half of the shift cable can be removed without removing the other half.
Perform the installation procedure that applies to the installation of that half of the shift cable.
1. Position the steering column shift lever to the park position.
2. Position the transmission manual shaft lever into the mechanical park position.
3. Install the two clips on the shift cable to the floor panel reinforcement.
4. Route the shift cable through the hole in the floor panel. Install the shift cable grommet to the floor panel.
5. Lower the vehicle.
6. Install the shift cable conduit end fitting to the steering column bracket.
Ensure the tangs fully seat (snap) into the steering column bracket.
7. Install the shift cable terminal shaft end to the steering column ball stud.
