K 2500 Truck 4WD V8-6.0L VIN U (1999)
5. If you are performing the extended method, apply a continuous 14 mm (0.55 in) high by 8 mm (0.32 in) wide bead of urethane adhesive to the
windshield sealing surface.
6. If you are performing the short method, apply a continuous 6 mm (0.25 in) bead of urethane adhesive to the existing urethane sealant.
7. Install the upper windshield molding.
8. With the aid of a helper place the windshield onto the windshield supports.
9. Use the tape guides applied earlier in order to adjust the windshield to the proper position.
10. Firmly press on the outer edges of the windshield in order to seat the urethane adhesive. Avoid excessive urethane adhesive squeeze-out.
11. In order to ensure a water tight seal, use a small flat blade tool in order to paddle the urethane sealant around the edge of the windshield. Apply
additional urethane sealant as needed in order to fill voids in the urethane sealant.
12. Using a soft spray of water, immediately test the effectiveness of the urethane sealant.
12.1. Softly spray warm or hot water around the outside edges of the windshield.
12.2. If any water leaks are present inside the vehicle, apply additional urethane sealant to the leak area using a flat blade tool.
12.3. Dry the windshield and the body.