K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
Radio/Stereo: Service and Repair
Radio Replacement
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
1. Disconnect the negative battery cable.
2. Remove the instrument panel trim.
3. Use a small screwdriver in order to release the radio retainers.
4. Slide the radio forward in order to remove the radio.
5. Remove the electrical connectors.
6. Remove the antenna connection.
INSTALLATION PROCEDURE
1. Install the antenna connection.
2. Install the electrical connectors.
3. Slide the radio into the instrument panel in order to install the radio.
The unit should snap into the retainers when the unit is fully seated.
4. Install the instrument panel trim.
5. Install the negative battery cable.
6. Verify the components operation.
