K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
rollers at normal service intervals with 30 weight engine oil. Do not lubricate hinge roller to hold-open link contacting surfaces. This may prevent the
roller from rolling properly.
Door Module
Removal Procedure
1. Disconnect the negative battery cable.
2. Lower the window.
3. Remove the trim panel.
4. Remove the water deflector.
5. Carefully pry out the retainer clips in order to remove the speaker, as necessary.
6. Remove the inner panel bolts.
7. Remove the lock rods from the following components:
^
The lock handle
^
The lock lever
^
The lock rod guides
8. Disconnect the wiring harness.
9. Slide the inner mounting panel rearward in order to release the regulator roller from the window sash.
Remove the inner mounting panel.
Installation Procedure
1. Slide the inner mounting panel forward in order to release the regulator roller from the window sash. Install the inner mounting panel to the
window sash.
2. Connect the wiring harness.
3. Install the lock rods to the following components:
^
The lock handle
^
The lock lever
^
The lock rod guides
4. Install the inner panel bolts.
