K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
6. Connect the negative battery cable.
Power Door Lock Switch
Removal Procedure
1. Disconnect the negative battery cable.
2. Remove the power accessory switch plate.
3. Disconnect the power door lock switch wiring connector.
4. Carefully bend the retaining tabs of the power door lock switch outward while pushing the switch out of the plate.
Remove the switch.
Installation Procedure
1. Install the power door lock switch.
2. Connect the power door lock switch wiring connector.
3. Install the power accessory switch plate.
4. Connect the negative battery cable.
Trim Panel Upper Extension
Removal Procedure
Tool Required:
J 38778 Trim Panel Remover
1. Remove the trim panel from the door by completing the following steps:
1.1. Using the J 38778, carefully pry the retainer from the door.
1.2. Pull upward in order to release the extension from the trim panel.
2. Remover the retainer from the extension.
Installation Procedure
1. Install the retainer to the extension.
2. Install the extension to the door by completing the following steps:
2.1. Insert the extension onto the trim panel.
2.2. Align the retainer into the hole in the door.
2.3. Push the extension until the retainer seats.
Water Deflector Replacement - Door
