K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
3. install the new bolt boots (1), (2).
4. Install the caliper.
5. Fill both housing cavities between the bushings with or the equivalent.
6. Install the mounting bolt and the sleeve assemblies.
^
Tighten the bolt to 51 Nm (38 ft. lbs.). The bolts boots must remain secure after tightening the bolts.
NOTICE: Refer to Fastener Notice in Service Precautions.
7. Connect the brake hose to the caliper.
^
Tighten the brake hose bolt to 45 Nm (33 ft. lbs.).
8. Measure the clearance between the caliper and the bracket stops.
^
If necessary, remove the caliper and file the ends of the bracket to obtain a 0.26 to 0.60 mm (0.010 to 0.024 inch) total clearance.
^
Measure the clearances individually and then add them together.
^
Install the tire and the wheel.
Important: Pump the brake pedal until it is firm before moving the vehicle. Check the fluid level in the master cylinder after pumping the brakes.
Bendix
REMOVAL PROCEDURE
1. Remove two-thirds of the brake fluid from the master cylinder.
