K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
2. Raise the vehicle.
3. Support the vehicle with safety stands.
4. Mark the relationship between the wheel and the hub.
5. Remove the tire and the wheel.
6. Position a C-clamp and tighten until the piston bottoms in the bore.
7. Remove the C-clamp.
8. Remove the brake hose.
9. Remove the bolt (2).
10. Remove the support key and the spring using a brass punch and a hammer to drive out the support key.
11. Remove the caliper assembly.
12. Inspect the inside of the caliper assembly for signs of fluid leakage.
13. Use a wire brush to remove any corrosion from the machined surfaces of the anchor plate and the caliper.
INSTALLATION PROCEDURE
