K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
12. Remove the caliper assembly (1).
13. Inspect the inside of the caliper assembly for signs of fluid leakage.
14. Use a wire brush to remove any corrosion from the machined surfaces of the anchor plate and the caliper.
INSTALLATION PROCEDURE
1. Lubricate the caliper and the anchor plate sliding surfaces with Shell Aeroshell Grade 5 lubricant or equivalent.
NOTICE: Do not use NEVER SEIZE type products on the caliper V-ways and anchor plate guide way surfaces. These products are not lubricants
and result in high caliper slide forces which can cause increased wear of the brake pads.
2. Install the caliper assembly (1).
3. Install the spring (4) and the support key (3).
4. Drive the support key in place using a brass punch and a hammer.
