K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
5. Install the bolt (2). The boss on the bolt must fit into the circular cutout in the key.
^
Tighten the bolt to 20 Nm (15 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
6. Install the brake hose.
^
Tighten the brake hose to 45 Nm (33 ft. lbs.).
NOTICE: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
7. Bleed the system.
8. Install the tire and the wheel assembly.
9. Lower the vehicle.
Important: Pump the brake pedal until it is firm before moving the vehicle. Check the brake fluid level in the master cylinder after pumping the
brakes.
