K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
4. Center the valve rocker arm on the corresponding holes in the valve rocker arm shaft.
5. Use a drift of at least 13 mm (1/2 inch) in diameter to install new retainers to the valve springs.
NOTICE: Improper installation of the valve rocker arm shaft bolts may cause valve rocker arm shaft breakage and piston to valve contact.
6. Install the valve rocker arm shaft assembly to the cylinder head.
NOTICE: Refer to Fastener Notice in Service Precautions.
7. Install the valve rocker arm shaft bolts to the cylinder head.
Tighten the bolts to 55 Nm (40 ft. lbs.).
8. Install the valve rocker arm cover to the cylinder head.
9. Install the lower intake manifold to the cylinder heads.
10. Install the upper intake manifold to the lower intake manifold.
11. Connect the battery negative cable to the battery.
