K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
1. Apply a 2 mm (1/16 inch) bead of RTV sealant GM P/N 12345739 to the oil pan rear seal at the inside corners where the seal meets the rear
crankshaft bearing cap on the engine block.
2. Install the oil pan rear seal to the rear crankshaft bearing cap before the sealer starts to dry.
3. Install the oil pan to the engine block.
NOTICE: Refer to Fastener Notice in Caution and Notices.
4. Install the oil pan bolts to the engine block.
4.1. Tighten the bolts in the following order:
4.2. Tighten the two rear bolts to 17 Nm (23 ft. lbs.).
4.3. Tighten all the other bolts to 10 Nm (89 inch lbs.).
5. Install the clutch assembly to the flywheel (if removed).
6. Install the transmission in the vehicle.
7. Install the transfer case in the vehicle if equipped.
8. Lower the vehicle.
9. Install the oil level indictor and tube to the engine block.
10. Fill the crankcase with engine oil.
11. Connect the battery negative cables to the batteries.
