K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
3. Install the fuel injection pump drive gear to the camshaft.
NOTICE: Refer to Fastener Notice in Caution and Notices.
4. Install the bolts from the timing chain sprocket to the camshaft.
Tighten the bolts to 25 Nm (20 ft. lbs.).
5. Install the engine front cover to the engine block.
6. Install the water pump to the engine block.
7. Install the crankshaft balancer to the crankshaft.
8. Install the lower fan shroud to the radiator.
9. Install the drive belt on the vehicle.
10. Install the upper fan shroud to the radiator.
11. Refill the cooling system.
12. Connect the battery negative cables to the batteries.
