K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
Blower Motor Resistor: Service and Repair
Primary Heating System
Blower Motor Resistor
Remove or Disconnect
1. Negative battery cable.
2. Roil instrument panel back.
3. Plenum tray.
4. Electrical connector.
5. Screws.
6. Resistor.
Install or Connect
NOTICE: When installing resistor to the heater case, do not let the resistor coils contact each other. Improper system operation or vehicle
damage could result.
1. Resistor.
2. Screws.
Tighten
-
Screws to 1.4 N.m (12 lb in).
3. Electrical connector.
4. Plenum tray.
5. Roll instrument panel forward.
6. Negative battery cable.
-
Check circuit operation.
