K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
4. Install the oil pan and a new gasket.
5. Install the oil pan bolts.
Alternately, and evenly, tighten the oil pan to transmission case bolts to 11 Nm (97 inch lbs.).
NOTICE: Do not reuse automatic transmission bolts and washers if the conical washer is reversed. Failure to replace the oil pan bolts and
washers may result in improper fastening of the system components.
NOTICE: Refer to Fastener Notice in General Information.
6. Install the upper and lower underbody braces, if equipped.
7. Lower the vehicle.
8. Fill the transmission to the proper level. Use DEXRON (R) III, or if unavailable, DEXRON (R) II.
NOTICE: Do not overfill the transmission. Overfilling will result in foaming, loss of fluid, and possible damage to the transmission.
9. Check the COLD fluid level reading for initial fill only. Refer to Transmission Fluid Checking Procedure,
10. Inspect the oil pan gasket for leaks.
