K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
10. Remove the glow plug from cylinder 8.
NOTE: For easier access to glow plugs on cylinders 6 and 8, removing the exhaust down pipe from turbocharger may be necessary.
INSTALLATION PROCEDURE
1. Install the glow plug into cylinder 8.
Tighten
^
Tighten the glow plugs to 17 Nm (13 lb. ft).
2. Connect the lead wire to the cylinder 8 glow plug.
3. Install the glow plugs into cylinders 2, 4, and 6 by reaching through the right front wheel well.
Tighten
^
Tighten the glow plugs to 17 Nm (13 lb. ft).
4. Install the lead wire to glow plug 6.
^
Slide the shroud over the wire lead.
^
Fasten the shroud to the studs.
^
Repeat Step 4 for the cylinder 4 glow plug.
Tighten
^
Tighten the heat shroud nuts to 23 Nm (17 lb. ft).
5. Connect the wires for the glow plugs in cylinders 4 and 6 to the connectors at the wire harness.
6. Install the lead wire for the cylinder 2 glow plug.
7. Install the splash shield in the right front wheel well.
8. Inspect the wire routing, ensuring that the lead wires are not rubbing against the exhaust manifold or any part that may harm the wire insulation.
9. Install the right front tire.
