K 2500 Truck 4WD V8-6.5L DSL Turbo VIN S (1998)
Transmission Speed Sensor: Service and Repair
4L60-E Automatic Transmission
REMOVAL PROCEDURE
1. Disconnect the negative battery cable from the battery negative terminal.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Raise the vehicle. Support the vehicle. Refer to Vehicle Lift Points.
3. Remove the electrical connector at the vehicle speed sensor.
4. Remove the retaining bolt and the sensor.
INSTALLATION PROCEDURE
1. Install the vehicle speed sensor and the retaining bolt.
-
Tighten the bolt to 10 Nm (89 inch lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the electrical connector at the sensor.
3. Remove the safety stands.
4. Lower the vehicle.
5. Connect the negative battery cable.
-
Tighten the terminal bolt to 15 Nm (11 ft. lbs.).
